Currently this firmware supports both KNOMI V1 and KNOMI V2.
- Firmware 2 times smaller, enabled OTA (in web browser knomi/update)
- All images are moved to second partition
- Code a lot cleaner, cut all factory-test stuff, switched back to official esp32-arduino platform
- Nicer webui
- Can change images using webui without reflashing firmware
- Any size of gifs are supported on KNOMI V1, even 240x240
- All communications are async - performance is better
- Much faster react to klipper updates - thanks to websockets being used instead of polling.
- Based on Knomi V1 - meaning no touchscreen / menus on Knomi V2 devices.
- First setup on iOS is not that nice. Enter "http://KNOMI/" to open initial setup in Safari. On Android / Windows regular captivity portal should open.
- Unofficial fork - support is on best-effort basis
- Please include "knomi.cfg" from repo to your klipper installation. You can comment out some sections if you don't have bed mesh or QGL.
- Connect your KNOMI display directly to PC in flash mode (hold the button and then connect the cable).
- Download installer from latest release from GitHub releases - it will guide you on first installation.
You can download filesystem / firmware from github releases and install them from KNOMI webpage.
If major version changed (1.0.0 -> 2.0.0) - then you MUST update filesystem (theme), it had some incompatible changes.
If minor version changed (1.0.0 -> 1.1.0) - then you can just upgrade firmware, all changes were backwards compatible.
For building you need nodejs installed and available on path.
