Bearings

[Cullen-Dubbs]

Hi there,

I am a little confused about the bearings. I have the 16mm OD bearings you have on the parts list. I somewhat see what the design calls for with the slot in the center for the bearing to go into. But I am not able to fit the bearing in. Do I need to place the bearing in there mid print?

[G-Levine]

Yes that’s correct, the bearing goes in mid-print. Sorry, the instructions aren’t clear. I will update them to explain it better.

…

On Apr 29, 2019, at 8:36 AM, Cullen-Dubbs ***@***.***> wrote: Hi there, I am a little confused about the bearings. I have the 16mm OD bearings you have on the parts list. I somewhat see what the design calls for with the slot in the center for the bearing to go into. But I am not able to fit the bearing in. Do I need to place the bearing in there mid print? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#1>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ACZIQQVEVB6K2BRFDVK6YMTPS4IXBANCNFSM4HJENNIQ>.

[Cullen-Dubbs]

No problem! I'm having alot of fun putting this together!

[createthis]

Is there a specific height at which the print should be paused? I’m printing on an Ultimaker 2+ and I’m trying to figure out how to make this happen most efficiently.