Boots to black screen #1689
-
Hi, I have an ender 3 v2. Was running 135b 3x3 manual mesh for months and upgraded to 201 3x3 a couple weeks ago. Everything was fine until yesterday when I power up the printer and the screen is blank. If I flash it again with 201 3x3 manual mesh it comes back. I thought I was a fluke and changed and my needed savings and leveled again. Turned it on today and same issue. Reinstalled firmware and it’s up and running. What can I do next? I don’t want to set it up every time I use it. Thanks in advance! |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 4 replies
-
Try using a different SD card. If that does not fix it, the mainboard may be failing. |
Beta Was this translation helpful? Give feedback.
-
As others suggested I am 99% sure this was the SD card. I have updated the firmware, reset to defaults and had no issues until I accidentally used the card again and powered on the printer. I cut that card in half and junked it! Appreciate the time and suggestions! |
Beta Was this translation helpful? Give feedback.
Try using a different SD card. If that does not fix it, the mainboard may be failing.
Another cause may be connector. Unplug and plugin all the connectors, even on the mainboard.