Manual Mesh Leveling - Manual Tuning

[wbvczar]

I am running this latest version of Jyers firmware on my Ender 3 v2. Under the Level menu, there is an option for "Manual Tuning". I use this function after creating a new Mesh. After I print the leveling calibration print, I then go into "Manual Tuning" and adjust at each point to fine tune the mesh. I love this option as I don't have to re-create the entire mesh.

My question is; can I enable this on my Ender 3 Pro? I have upgraded the board to the 4.2.7 board and I still have the original LCD screen. Is there something to enable in the Configuration.h file? Is this even possible on the original LCD screen? I have enabled Mesh Bed Levelling on the 3 Pro, but I don't have the "Manual Tuning" option.

[Cal-LF]

@wbvczar The E3 pro LCD screen is not supported. If you changed it to a E3V2 screen, it should work.

[wbvczar]

Thank you!