Pwnagotchi-Flipper interface

This program will interface the pwnagotchi with the flipper. This will be accomplished using custom code on the pwnagotchi's end to give the flipper simple rendering instructions over UART.

Layout

This project is broken down into two parts: flipagotchi and pwnzero

pwnagotchi-flipper
 |--> flipagotchi/
 |--> pwnzero/

• flipagotchi is the Flipper-side application
• pwnzero is the pwnagotchi-side application

Setup

Flipagotchi Setup (Flipper side)

The flipagotchi app can be downloaded from the flipper app store. If you would like to do things manually then follow these instructions.

1. Connect your Flipper to your computer
2. Clone the Flipper Zero firmware onto your machine
3. Place the flipagotchi/ directory into the applications_user/
4. Open a terminal and navigate to the root of the firmware
5. Execute the following command to compile the app and launch it on the Flipper:
   ./fbt launch_app APPSRC=applications_user/flipagotchi
6. This will now compile and load the app onto your Flipper

PwnZero Setup (Pwnagotchi side)

This procedure will explain how to configure the Pwnagotchi to use the PwnZero plugin to communicate with the Flipper. Note: You may need to change the pyserial file name based on whichever version pip downloaded for you.

1. On your host machine run pip3 download pyserial, this should download a .whl file.
2. Take note of the filename of the .whl and insert that instead of mine
3. Also on the host, run scp pyserial-3.5-py2.py3-none-any.whl pi@10.0.0.2:/home/pi to transfer the .whl file to the pwnagotchi
4. Now on the pwnagotchi install the module as root with sudo pip3 install /home/pi/pyserial-3.5-py2.py3-none-any.whl
5. Disable Bluetooth on the Pi by adding dtoverlay=disable-bt at the bottom of the /boot/config.txt file
   1. This needs to be disabled so that the full UART is directed to /dev/serial0
6. Enter the raspberry pi configuration settings with sudo raspi-config
   1. Select Interface Options
   2. Select Serial Port
   3. Select No for shell over serial
   4. Select Yes for serial enabled
7. Place the PwnZero.py file somewhere on the Pi in either its own folder or a folder with other plugins
8. Edit /etc/pwnagotchi/config.toml file and set main.custom_plugins = "/path/to/plugin/folder"
9. Follow hardware setup shown in doc/HardwareSetup.md to connect the devices
10. Restart the Pwnagotchi and open the Flipagotchi app on the Flipper Zero

Setup note

Chrismettal has designed a "backpack" for the Flipper Zero which is a board that allows you to cleanly attach various devices to the Flipper. They have created one for the Raspberry Pi Zero W which would be a great way to keep your Flipagotchi tidy! Here is a link to their project.

Development stages

Stage 1: Simple display rendering

• Stage 1 will focus on getting the Pwnagotchi display to render on the Flipper's display

Stage 2: App interaction

• Stage 2 will allow the user to interact and control the pwnagotchi using the Flipper's interface

Contributing

If you would like to contribute, you may make a pull request. It will be helpful if you first open an issue describing the change that you are interested in contributing.

License

MIT

Disclaimer

This program is meant for educational purposes ONLY. I disclaim any and all responsibility for the usage of this program by external parties (not me).