There is no information on how to setup tidal

[cherryontopknife]

We're told to check the output logging, but I don't see anything in the console that describes how to setup tidal with lidarr-extended.

Even simple steps on what to do would be much appreciated.

[RandomNinjaAtk]

There isn't really anything to setup. Basic instructions:

1. Restart/Start docker container
2. Watch Container console log
3. Authenticate when prompted

Basically the scripts with autostart enabled, will kick off after about 2-3min after the container is first started. And in the console output, you'll see a prompt to authenticate the tidal client when it attempts to use it.

Edit: If using webhook feature, you will be notified via webhook when authentication is required. (https://github.com/RandomNinjaAtk/docker-lidarr-extended#parameters)

[cherryontopknife]

Thanks for responding.

I have both the console open and the logs open. I start Lidarr, and after 2 minutes the scripting starts. My logs have information about Tidal, but I don't see anything about how to authenticate in either the console or the log.

[RandomNinjaAtk]

Wait a bit longer, you will see it in the log output, its really all I can tell you, its not a perfect solution, but there is no other solution to improve it that I'm aware of.... If you use the webhook feature, you'll get a notification via the webhook when its required:
https://github.com/RandomNinjaAtk/docker-lidarr-extended#parameters

[RandomNinjaAtk]

Updated the readme, with a link to this issue describing the process for authing. I would recommend that you use the webhook, it makes it was simpler to track when it needs your attention.