You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Linux (UltiMaker-Cura-5.6.0-linux-X64_cbc4dfea87e29f7635e925d1ba0769c0.AppImage)
Printer
Creality Ender 3 v3 SE
Reproduction steps
Downloaded a fresh AppImage, launched and configured for my printer, performed a slice on a known good STL. Slice completed normally.
Installed the CuraEngine Tiled Infill Generation 0.2.0 Plugin, restarted the application.
Opened the same STL that sliced correctly, performed a slice, slice fails.
In troubleshooting, I disabled the plugin, restarted Cura, performed the same test and the slice was successful.
Cura Version
5.6.0
Operating System
Linux (UltiMaker-Cura-5.6.0-linux-X64_cbc4dfea87e29f7635e925d1ba0769c0.AppImage)
Printer
Creality Ender 3 v3 SE
Reproduction steps
Downloaded a fresh AppImage, launched and configured for my printer, performed a slice on a known good STL. Slice completed normally.
Installed the CuraEngine Tiled Infill Generation 0.2.0 Plugin, restarted the application.
Opened the same STL that sliced correctly, performed a slice, slice fails.
In troubleshooting, I disabled the plugin, restarted Cura, performed the same test and the slice was successful.
Actual results
Error is generated
Expected results
successful slice
Add your .zip and screenshots here ⬇️
cura.log
CuraEngineTiledInfill.log
The text was updated successfully, but these errors were encountered: