Description
I can not get the nano every reset by sending the 1200 baud signal and I am thinking this might because of the atsamd11d14a is not doing that.
I noticed the latest commit on the MuxTO is to "Reset 4809 on baudrate change / port open".
I don't really like the reset on port open, but I do like the reset 4809 on the 1200 baud. I am thinking if i can compile the project and load the firmware, then I might be able to modify it to only reset at 1200 baud and not reset at port open.
So I try to compile the firmware, and found out that is not easy:
https://forum.arduino.cc/t/compiling-and-loading-the-muxto-code/627145
and also I got the file size
/home/myname/.arduino15/packages/arduino/tools/arm-none-eabi-gcc/4.8.3-2014q1/bin/../lib/gcc/arm-none-eabi/4.8.3/../../../../arm-none-eabi/bin/ld: MuxTO.ino.elf section .text' will not fit in region FLASH'
/home/myname/.arduino15/packages/arduino/tools/arm-none-eabi-gcc/4.8.3-2014q1/bin/../lib/gcc/arm-none-eabi/4.8.3/../../../../arm-none-eabi/bin/ld: region `FLASH' overflowed by 112 bytes
collect2: error: ld returned 1 exit status
exit status 1
Error compiling for board Generic D11D14AS.
By change the Bootloader size to compile with "no bootloader", the GUI can compile. Then I try to upload it
I connected USB with the SWDIO and GND pins as instructed in the getting started (https://www.arduino.cc/en/Guide/NANOEvery#firmware-for-samd11d14a : To reprogram the D11, simply power it while shorting SWDIO to GND pins.)
Then I have the
Bus 001 Device 048: ID 2 341:5058 Arduino SA MuxTO BL
and also have
/dev/ttyACM0
Selecting the Mattair generic D11D14AS
I can not upload the
I am using a debian 11 and arduino 1.8.16. using the latest clone from the git 4137a5 of this repo.