Add option in my_user_config.h to turn on SDM630 import active energy #9124
Conversation
| @@ -637,6 +637,7 @@ | |||
| #define SDM120_SPEED 2400 // SDM120-Modbus RS485 serial speed (default: 2400 baud) | |||
| //#define USE_SDM630 // Add support for Eastron SDM630-Modbus energy monitor (+0k6 code) | |||
| #define SDM630_SPEED 9600 // SDM630-Modbus RS485 serial speed (default: 9600 baud) | |||
| //#define SDM630_IMPORT // Show import active energy in MQTT and Web (+0k3 code) | |||
There was a problem hiding this comment.
Does this setting depend on USE_SDM630 somehow?
There was a problem hiding this comment.
By default, Tasmota reads multiple ModBus registers from SDM630 but without 0x015A, 0X015C, 0x015E (phase 1, 2 and 3 import active energy). I have been using the extended version that reads these registers for four months now and it works very well. For users who need to read the consumed energy separately for each phase, there is this switch - #SDM630_IMPORT. This works ONLY if the SDM630 is compiled in the firmware as before (tasmota-sensors etc).
There was a problem hiding this comment.
Well, I mean, does the code compile if SDM630_IMPORT is defined but USE_SDM630 is not?
There was a problem hiding this comment.
SDM630_IMPORT work only if USE_SDM630 is defined.
arendst
added
the
on hold by dev team
Add SDM630 three phase ImportActive Energy display when ``#define SDM630_IMPORT`` is enabled by Janusz Kostorz (#9124)
Description:
Related issue (if applicable): fixes #
Checklist:
NOTE: The code change must pass CI tests. Your PR cannot be merged unless tests pass