Project ORC4

A 42-key ortholinear keyboard with a knob and screen. Based off of the ScottoGame by Joe Scotto.

• Keyboard Maintainer: Starry Knight
• Hardware Supported: rp2040 (using the adafruit kb2040), firmware written for ATmega32U4
• Hardware Availability: Amazon (https://amazon.com) & Digikey (https://https://www.digikey.com/)

Make example for this keyboard (after setting up your build environment):

make project_orc4:default

Flashing example for this keyboard:

make project_orc4:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available