OctoPrint plugin that integrates with a filament sensor hooked up to a Raspberry Pi GPIO pin and allows the filament spool to be changed during a print if the filament runs out.
Future developments are planned to include multiple filament sensors and pop-ups.
Initial work based on the Octoprint-Filament plugin by MoonshineSG.
Using this plugin requires a filament sensor. The code is set to use the Raspberry Pi's internal Pull-Up resistors, so the switch should be between your detection pin and a ground pin.
This plugin is using the GPIO.BOARD numbering scheme, the pin being used needs to be selected by the physical pin number.
- Configurable GPIO pin.
- Debounce noisy sensors.
- Support norbally open and normally closed sensors.
- Execution of custom GCODE when out of filament detected.
- Optionally pause print when out of filament.
- Install via the bundled Plugin Manager.
- Manually using this URL: https://github.com/kontakt/Octoprint-Filament-Reloaded/archive/master.zip
After installation, configure the plugin via OctoPrint Settings interface.