This is a series of targets based around a breadboard prototype:

Support for the following:

Only GPIO 20 is used for PWM audio output.

Audio	Display mode	Firmware
HDMI	640x480x60Hz	sorcerer2_hdmi_hdmi_audio.uf2
1 pin PWM	640x480x60Hz	sorcerer2_demo_dv_i2s_audio.uf2

Pi Pico Wiring table

	SPI0	GPIO	Pin	SPI	MicroSD 0	HDMI/DVI	Description
MISO	RX	4	6	DO	DO		Master In, Slave Out
CS0	CSn	5	7	SS or CS	CS		Slave (or Chip) Select
SCK	SCK	2	4	SCLK	CLK		SPI clock
MOSI	TX	3	5	DI	DI		Master Out, Slave In
CD		22	29		CD		Card Detect
GND			3		GND		Ground
3v3			36		3v3		3.3 volt power
GND			18,23			GND	Ground
GP16		16	21			TX2+	Data channel 2+
GP17		17	22			TX2-	Data channel 2-
GP18		18	24			TX1+	Data channel 1+
GP19		19	25			TX1-	Data channel 1-
GP12		12	16			TX0+	Data channel 0+
GP13		13	17			TX0-	Data channel 0-
GP14		14	19			TXC+	Clock +
GP15		15	20			TXC-	Clock -
GP20		20	26				PWM audio out
GP6		6	9				PS/2 data (RP_PS2_DATA)
GP7		7	10				PS/2 clk (RP_PS2_CLK)

Provide feedback