Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Add LYIF722D TARGETS
The LYIF722D is a flight controller that uses the STM32F722RGT6 MCU and has dual gyroscopes. this is an unofficial target .The input voltage ranges from 7V to 40V, which is equivalent to 2-8S. It has BECs of 5V 3A and 12V 3A, and it comes with an OSD, a barometer, and 1-8 DSHOT motor outputs.I will provide pictures, definitions and other content related to the corresponding products within the topics discussed below.
(Brand): | LYI
(Model): | LYI-F722D
(MCU): | STM32F722RGT6
(Gyro): | ICM42688Px2(Dual gyro)
(OSD): | AT7456E
(Baro) | SPL06
(Blackbox): | 16MB
(Input Voltage): | 7-40V(2-8S)
(BEC): | 5V@3A, 12V@3A
(UART): | UART1,UART2,UART3,UART4,UART5,UART6
(Firmware): | INAV7.12
(Hole Spacing): | 30.5x30.5mm
(Weight): | 7.5g
Test results and flight reports: It is convenient to weld, stable, with low gyroscope noise, rapid response, high accuracy of the barometer, and it can achieve stable hovering as well as fixed altitude and fixed point.
Add interface definitions.
If you have any questions, please feel free to give your advice. Thank you.