The arduino/
directory contains the source files for the Arduino sketch that will be run on the Arduino Mega.
You can compile it by running make
in the directory.
NOTE: You will need to use the latest version of Arduino IDE (>1.8.0). The version provided in the Debian/Ubuntu repositories is very old, go download it from the Arduino website instead.
- Set the
ARDUINO_DIR
environment variable to the location of your Arduino installation e.g./usr/share/arduino
. cd
to thearduino/
directory in this project.- Run
make
to compile the sketch, or runmake upload
to compile and upload the sketch.
The raspi-service.py
script will install the necessary systemd unit files to run raspi-uart
, raspi-ml
and raspi-eval
as a service.
Undeterministic things will happen if you run multiple copies of this software at the same time, so when e.g. running the raspi-uart
program on the command line, make sure its associated service (raspi-uart.service
) has been stopped first.
Clone the git repository into the raspberry pi and run make
in the relevant directories to compile the relevant software:
raspi-monitor
: A simple program which prints all incoming UART messages to stdout.raspi-uart
: The UART communication program that is run on the system.
Run them directly, but you will need to have the necessary dependencies installed first.
raspi-ml.py
: Machine learning processraspi-eval.py
: Evaluation server communication process.
Located at libraries/ucomm
.
The ucomm
library is used for UART communication between the Arduino and Raspberry Pi.
It will automatically be compiled and linked against the software (i.e. arduino, raspi-uart) that needs it.
Run make test
in the directory to compile and run some tests.
-
Write the Raspbian Image to the Raspberry Pi, i.e.
dd bs=4M if=2017-08-16-raspbian-stretch-lite.img of=/dev/sdX oflag=sync status=progress partprobe /dev/sdX
-
Mount the
/boot
partition of the SD card.-
Create an empty
ssh
file in the/boot
partition, i.e. (in the mounted/boot
partition directory)sudo touch ssh
-
Open
/boot/cmdline.txt
and:- Remove the console entry that refers to
serial0
, i.e.console=serial0,115200
. - Append
net.ifnames=0
to the end.
- Remove the console entry that refers to
-
Open
/boot/config.txt
, and add the following line to the end of the file:dtoverlay=pi3-disable-bt
-
-
Mount the root partition of the SD card.
-
Open
/etc/dhcpcd.conf
, and look for the following similar lines and modify it such that it looks like:# Example static IP configuration: interface eth0 static ip_address=192.168.3.2/24
where
192.168.3.2
is your desired static IP.There is no need to specify a
routers
ordomain_name_servers
.
-