lace holes in the wrong places

[jaredjennings]

When I made the eggcrate-splitters, I left some room between where the eggcrate splits the plastic in two pieces and where the holes are where you lace the pieces together while gluing.

One problem has shown up two ways: I printed the first bottom piece, and it had holes on its left edge. This means it isn't wide enough, and it also means the lace holes need to be closer to the split.

[jaredjennings]

Oh and the last piece has a couple of little bites out of it because the last double eggcrate box doesn't cover the rightmost edge entirely

[jaredjennings]

OBE #50. There will be another "tweak hexagonal pieces, splits are in the wrong place" ticket.