A open source hackable handheld for DIY.
UPDATE: No need to worry on this project failing to build as I have received the parts and have tested everything and can verify the PCBs are working fine. Although due to the updated removal of solder pads, I will have to reorder the PCBs and see if the manufacturers are able to create it without any problems. I will update this repo when finished. DISCLAIMER: There is no 3d print case designed for this project yet. If you'd like to contribute, please feel free to!
This is a redesign of SpaceHuhn's Hackheld Vega but with a 5 direction switch and a smaller board.
It can run the ESP8266 Deauther, but you can also write your own firmware using Arduino.
Download Gerbers For Single Rectangular Board
Note: removed double board as panelisation should be done instead. You can panelise the PCBs easily with EasyEDA or other alternatives. For a 100mm x 100mm PCB, you can fit 2 in a row and no more in a column. The dimensions of a single Hackheld in this project is 43.5mm x 53.5mm.
Also the only method I could figure out to remove those holes in the solder pads were making them microscopical, meaning that some pcb manufacturers may tell you that they have skipped or have a problem with this.
I highly recommend buying the exact same parts as the section down below as many manufacturers use different 5 directional switches and I've designed the routes according to the one thats listed.
I recommend JLCPCB as they have fast shipping, cheap options and have several discounts. PCBWay is also a good alternative.
Please star this repository if you appreciated my work and would like to help me out!! Thanks in advance.
To flash the esp8266 board, please visit https://github.com/SpacehuhnTech/Hackheld
Everything is purchased from Aliexpress and have been carefully selected so they are the cheapest avaliable options for most people:
1.3" display(can alternate but ensure the pins are VDD,GND,SCK,SDA): https://www.aliexpress.com/item/4001145494936.html
D1 mini(can alternate but ensure that you are getting one with the correct dimensions): https://www.aliexpress.com/item/32816149164.html
WS2812B 5050 RGB LED: https://www.aliexpress.com/item/1005002653014067.html
6*6 buttons(4 pin): https://www.aliexpress.com/item/33046122537.html
5 direction button(not suitable for alternatives): https://www.aliexpress.com/item/33024133078.html
Simple soldering and wire cutters may be needed to solder on + make sure the parts fit(the pins might be too long).
Original Hackheld by SpaceHuhn: https://github.com/SpacehuhnTech/Hackheld Inspiration + original creator(of the firmware too)! Thx Stefan.
DSTike hackheld schematics: https://github.com/lspoplove/Deauther-Project Used schematics to view more detailed wiring
ItsKarilito: https://github.com/ItsKarlito/Hackheld Redesigned the PCB and fixed some errors on the original Hackheld
This is open source, just like the original hackheld!