initial port of little-kernel to vc4 #259
Draft
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
some parts are copy/pasted from https://github.com/cleverca22/rpi-open-firmware which itself is a fork of https://github.com/christinaa/rpi-open-firmware what works: network booting lk.elf on an rpi4 (just rename to start4.elf and host over tftp) the full console with line editing and history serial over pl011 (but no serial init, relies on previous bootloader stage) reboot command irq handling for timer compare and uart one-shot timer reporting cpu exceptions such as divide by zero
cleverca22
force-pushed
the
vc4
branch
5 times, most recently
from
72e853b
to
cd49878
Compare
add sdhost code add gpio pullup test fix peripheral address implement batch gpio pull config changes fix memory information to be based on boot stage, not model add rpi4 recovery.bin support
This is a clean rewrite of the OTP routines using new findings.
Based on previous research, this commit implements a write command.
Use with care!
What is done cannot be undone.
This bit does not tell whether programming was OK, but whether programming is enabled. Renaming should prevent confusion when BCM283x support is added.
The OTP chip in BCM283x cannot program a full word in a single command. Instead, individual bits must be programmed one by one. There is also a subtle difference in program enable. The magic sequence must be written to OTP_BITSEL, not OTP_DATA. Tested on a RPi3 B (no plus).
Enhance OTP handling
Get rid of hardcoded values in pll_control.c
overhaul arch setup for targets add support for .text.bootloader_state on the pi4
…bootloader hasnt initialized things
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
some parts are copy/pasted from https://github.com/cleverca22/rpi-open-firmware
which itself is a fork of https://github.com/christinaa/rpi-open-firmware
what works:
network booting lk.elf on an rpi4 (just rename to start4.elf and host over tftp)
the full console with line editing and history
serial over pl011 (but no serial init, relies on previous bootloader stage)
reboot command
irq handling for timer compare and uart
one-shot timer
reporting cpu exceptions such as divide by zero