Cloner

Takes a monophonic input (or the sum of the channels) and clones it to N polyphonic channels. The number of channels is determined by the knob, if no cable is connected to 'Channels'. If a cable is connected and carries a monophonic signal, the number of channels is 2*V, e.g. 5V -> 10 channels. If the a polyphonic cable is connected, the number of output channels equals the number of those in the 'channels' input.

The Spread knob and jack introduces a spread between the voltages of the output channels. The small switch allows to change between unipolar and bipolar spreads. The knob acts as an attenuator of the CV input, which is normalled to 2V.

The right-click option 'Legacy' switches between the old mode, in which the given spread is applied between every channel, and the new mode, where the input/knob value determines the total difference between the highest and lowest value. Output values of all channels are clamped between -10V and +10V.