net: phylink: initialize carrier state at creation

Background: Turris Omnia (Armada 385); eth2 (mvneta) connected to SFP bus;
SFP module is present, but no fiber connected, so definitely no carrier.

After booting, eth2 is down, but netdev LED trigger surprisingly reports
link active. Then, after "ip link set eth2 up", the link indicator goes
away - as I would have expected it from the beginning.

It turns out, that the default carrier state after netdev creation is
"carrier ok". Some ethernet drivers explicitly call netif_carrier_off
during probing, others (like mvneta) don't - which explains the current
behaviour: only when the device is brought up, phylink_start calls
netif_carrier_off.

Fix this for all drivers using phylink, by calling netif_carrier_off in
phylink_create.

Fixes: 089381b ("leds: initial support for Turris Omnia LEDs")
Cc: stable@vger.kernel.org
Suggested-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Klaus Kudielka <klaus.kudielka@gmail.com>
Reviewed-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/phylink.c

@@ -1616,6 +1616,7 @@ struct phylink *phylink_create(struct phylink_config *config,
 	pl->config = config;
 	if (config->type == PHYLINK_NETDEV) {
 		pl->netdev = to_net_dev(config->dev);
+		netif_carrier_off(pl->netdev);
 	} else if (config->type == PHYLINK_DEV) {
 		pl->dev = config->dev;
 	} else {