fix sporadic init failures, improve daly serial comm error rate #22
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Fixed errors that are probably follow-ups due to a changed init sequence or race condition. Some values were not yet set when requested for the boot messages. I changed the test_connection() routine to read these values earlier.
I digged a bit into the read errors and found that Daly has some issues with UART sync. I changed the protocol's unused fill bytes from 0x00 to 0xAA what is a common way to stabilize UART syncing and my log is almost clean of comm errors now.