pinctrl: intel: Set default bias in case no particular value given

[ Upstream commit f3c75e7 ]

When GPIO library asks pin control to set the bias, it doesn't pass
any value of it and argument is considered boolean (and this is true
for ACPI GpioIo() / GpioInt() resources, by the way). Thus, individual
drivers must behave well, when they got the resistance value of 1 Ohm,
i.e. transforming it to sane default.

In case of Intel pin control hardware the 5 kOhm sounds plausible
because on one hand it's a minimum of resistors present in all
hardware generations and at the same time it's high enough to minimize
leakage current (will be only 200 uA with the above choice).

Fixes: e57725e ("pinctrl: intel: Add support for hardware debouncer")
Reported-by: Jamie McClymont <jamie@kwiius.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>

drivers/pinctrl/intel/pinctrl-intel.c

@@ -621,6 +621,10 @@ static int intel_config_set_pull(struct intel_pinctrl *pctrl, unsigned pin,
 
 		value |= PADCFG1_TERM_UP;
 
+		/* Set default strength value in case none is given */
+		if (arg == 1)
+			arg = 5000;
+
 		switch (arg) {
 		case 20000:
 			value |= PADCFG1_TERM_20K << PADCFG1_TERM_SHIFT;
@@ -643,6 +647,10 @@ static int intel_config_set_pull(struct intel_pinctrl *pctrl, unsigned pin,
 	case PIN_CONFIG_BIAS_PULL_DOWN:
 		value &= ~(PADCFG1_TERM_UP | PADCFG1_TERM_MASK);
 
+		/* Set default strength value in case none is given */
+		if (arg == 1)
+			arg = 5000;
+
 		switch (arg) {
 		case 20000:
 			value |= PADCFG1_TERM_20K << PADCFG1_TERM_SHIFT;