Is it possible to display current layer numbers? #1212
Replies: 3 comments 2 replies
-
|
I do that using a slicer script and M117. |
Beta Was this translation helpful? Give feedback.
-
|
Could you elaborate for me please?
…On Fri, Jan 12, 2024, 00:40 Miguel Risco-Castillo ***@***.***> wrote:
I do that using a slicer script and M117.
—
Reply to this email directly, view it on GitHub
<#1212 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AOIUMBMJ7BK27JL7IU7H25LYODSHFAVCNFSM6AAAAABBW37M3WVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DCMBWGIZDA>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
Check: https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides#post-processing-scripts |
Beta Was this translation helpful? Give feedback.
-
|
Thank you, I started reading this one but obviously didn't get far enough. |
Beta Was this translation helpful? Give feedback.
-
|
I have read about the M117 command, but what I cannot determine is how to add this information. Can you post an example of the script that you use? |
Beta Was this translation helpful? Give feedback.
-
I am curious if it is possible to display layer numbers in addition to (or in lieu of) the progress meter?
I am thinking a simple "Printing Layer X / XXX" display. Is this a possibility?
Beta Was this translation helpful? Give feedback.
All reactions