The objective of this project is to provide an SDK and root file system for the Raspberry Pi that is lightweight and takes full advantage of the hardware available. The resulting image produced is small Linux distribution known as Bsquask.
The Bsquask SDK provides a GCC 4.6.3 toolchain for building armv6 binaries with the hard-float ABI, as well as bootloaders, kernel image, rootfs, and development sysroot for the Raspberry Pi.
Clone the RaspberryPi-BuildRoot project into your local code directory:
cd ~/Code/
git clone git://github.com/nezticle/RaspberryPi-BuildRoot.git BuildRoot
Create the directory where you want your SDK to be built:
export BSQUASK_DIR=/opt/bsquask
mkdir -p $BSQUASK_DIR
Enter the BuildRoot directory and generate a Makefile for your SDK:
cd BuildRoot
make raspberrypi_defconfig O=$BSQUASK_DIR
You may be missing some build dependancies (flex, bison, etc...) but you will be warned about what packages you need to install if this is the case. If you are using ubuntu the following command should install all needed dependancies:
sudo apt-get install flex bison texinfo mercurial git-core
Change to your SDK directory and and start the build (this can take a few hours the first time).
cd $BSQUASK_DIR
make
*Do not use the -j option with this Makefile! The optimum number of make jobs is determined by BuildRoot, and overriding this with the -j flag here breaks the build system.
First you need to obtain an SD card that has the correct partitions setup. It needs to be setup as follows:
- 75MB fat32 partition
- 500MB or greater ext4 partition (ideally using the remainder of the card)
If you need help with this, the Raspberry Pi wiki has a guide that's pretty close (make sure to use ext4 instead of ext3).
When you have this setup, mount the the two partitions (assuming /media/BOOT for the fat32 partiion, and /media/rootfs for the ext4). The run the following commands to install the rootfs:
cd $BSQUASK_DIR/images
tar -zxvf boot.tar.gz -C /media/BOOT
sudo tar -zxvf rootfs.tar.gz -C /media/rootfs
Make sure you are root(sudo) when extracting rootfs.tar.gz, or you will have problems on boot
Now place the SD card in your Raspberry Pi and power on. If everything went as planned, you should get a login prompt for Bsquask (linux).
username: root
password: root
Lets set a few more environment variables to make things easier:
export BSQUASK_HOST_DIR=$BSQUASK_DIR/host
export BSQUASK_STAGING_DIR=$BSQUASK_DIR/staging
export BSQUASK_TARGET_DIR=$BSQUASK_DIR/target
$BSQUASK_HOST_DIR is the directory containing the native built tools for your machine like your cross compiler. If you want to make use these tools then you will want to add these them to your path:
export PATH=$BSQUASK_HOST_DIR/usr/bin:$PATH
$BSQUASK_STAGING_DIR is the location of your sysroot. This is where you install everything that you've built for your device, including development headers and debug symbols.
$BSQUASK_TARGET_DIR is the location you use to build images. This is what you are deploying to your device, so only things you want to be in your images (like stripped binaries).
$BSQUASK_HOST_DIR/usr/bin/qmake yourproject.pro
make
./autogen.sh --host arm-raspberrypi-linux-gnueabi --prefix=$BSQUASK_STAGING_DIR/usr
make
cmake -DCMAKE_TOOLCHAIN_FILE=$BSQUASK_HOST_DIR/usr/share/buildroot/toolchainfile.cmake
make