Skip to content

MicroPython module for work with MAX7219 led matrix 8x8 display.

License

Notifications You must be signed in to change notification settings

octaprog7/MatrixDisplay

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

22 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

MAX7219

MicroPython module for work with MAX7219 led matrix 8x8 display.

Just connect your matrix display board to Arduino, ESP or any other board with MicroPython firmware.

Supply voltage display board from 4.0 to 5.0 volts! Use five wires to connect (SPI bus).

  1. +VCC (Supply voltage)
  2. GND
  3. COPI/SDO - Controller Out, Peripheral In
  4. SCK - Serial Clock
  5. CS - chip select

Connection diagram

If your microcontroller is powered by 5 volts, then you do not need a Level Shifter. If your microcontroller is powered by 3.3 volts, then you will need (!) a Level Shifter. Please see: https://www.raspberrypi-spy.co.uk/2018/09/using-a-level-shifter-with-the-raspberry-pi-gpio/

Warning! The operation of a microcontroller powered by a voltage of 3.3 Volts with a matrix indicator operating from 5.0 Volts can damage the MCU!

Arduino Nano RP2040 Connect with RP2040 Board

MCU board		Level Shifter	    Display
-------------------------------------------------------------------
D13 (SCK)  board pin	LV1<->HV1	    SCK display pin
D11 (COPI) board pin	LV2<->HV2	    DIN display pin
D10 (CS)   board pun	LV3<->HV3	    CS display pin
+3.3 V board pin	LV pin
+5 V board pin		HV pin
+5 V board pin		                    +5V display pin
GND board pin		GND pin	            GND display pin

Don't forget to short the SJ1 jumper on the underside of the MCU board! Please see Nano RP2040 Connect schematic: https://content.arduino.cc/assets/ABX00053-schematics.pdf

Upload

Upload MicroPython firmware to the NANO(ESP, etc) board, and then files: main.py, mtrx_disp.py and sensor_pack folder. Then open main.py in your IDE and run it.

Power Supply Requirements

It follows from the documentation that the typical current consumption of an 8x8 LED segment (all LEDs on) is 330 mA. Therefore, it can be considered that the segment draws about 200 mA at 5 Volts. If there are 4 segments, the consumption will reach 800 mA at 5 Volts. 8 segments consume 1.6 A at 5 Volts.

Capacitors

For every 4 segments, you need to install two capacitors in parallel with the power supply. The first is 100 uF x 16 Volts. The second 10 nF x 25..50 Volts. The terminals of these capacitors should be located as close as possible to the power terminals of the matrix indicator! The length of printed conductors or wires must be minimized!!! Without good power, the device will not work properly!

Pictures

IDE

alt text

Breadboard

alt text

Video

Link to video: https://www.youtube.com/watch?v=X4qcNem8NmY

About

MicroPython module for work with MAX7219 led matrix 8x8 display.

Topics

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages