Skip to content

Appendix G: Sourcing Your Own Ploopy

Jump to bottom
ploopyco edited this page Jul 25, 2022 · 1 revision

Sourcing your own parts, PCBs, and 3D-printed files? Great! Here are full instructions on how to do so!

1. Introduction

2. Electronics assembly

3. Enclosure assembly

4. Final assembly

Copyright (C) 2020, Ploopy Corporation.

Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.3 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts. A copy of the license is included in the section entitled "GNU Free Documentation License".

Home

Official Ploopy Kit Assembly

Ploopy Trackball Kit Assembly, Revision D

Ploopy Trackball Kit Assembly, Revision C

Appendices

Appendix A: Printed circuit boards

Appendix B: 3D-printed parts

Appendix C: QMK Firmware Programming

Appendix D: Programming QMK on Older Ploopy Devices

Appendix E: Firmware Programming (Non QMK Devices)

Appendix F: Hardware

Appendix G: Sourcing Your Own Ploopy

Legal

GNU Free Documentation License

Clone this wiki locally