FAQ

How to transfer files to/from the SD/LittleFS memory?

Use the WebUI

For AP mode wifi network the password is brucenet.

For the WebUI, username=admin, password=bruce

IR requires a line-of-sight between the transmitter and the receiver, which can be easily blocked by solid objects. Besides, other IR light sources like the sun may cause interferences. Solid objects can also block RF signals, especially if made of metal. Also, some nearby transmitters may cause interferences even if not using the exact same frequency.
try putting the transmitter and receiver closer (<10cm), many cheap modules have poor ranges, or may be too noisy.
if using unofficially supported modules, double-check that the used pins are correct. These can be changed in the Settings.
check if the module is active and working during transmission:
- for IR, you can use a smartphone camera to check if the IR LED is blinking.
- use a multimeter or an oscilloscope to check activity on the data pin/LED/antenna.
- use another device to check and compare the signals. e.g. rtl_433 for RF, Tasmota or a Broadlink RM4 Pro for both IR and RF.
most RF modules only supports the 433MHz frequency with ASK/OOK modulation. Check if your .sub file or source signal is compatible.
check the serial log for errors, some signals may fail to decode.

Not officially supported.

For boards that do not have screen and buttons, an headless mode was added. For this to work, you have to manually add a new target in the platformio.ini, and then define the pins and features for the modules you have connected. Then, compile the firmware for your new target and hope it works fine!

There is some file examples of what you can do in here, including evil portal templates, nfcs and infrared

🦈 Bruce - Predatory Firmware