Prevent voltage low warnings from filling log

Although the correct fix for low voltage warnings is to
improve the power supply, the current implementation
of the detection can fill the log if the warning
happens freqently. This replaces the logging with
slightly custom ratelimited logging.

drivers/firmware/raspberrypi.c

@@ -24,6 +24,36 @@
 
 #define UNDERVOLTAGE_BIT		BIT(0)
 
+
+// This section defines some rate limited logging that prevent
+// repeated messages at much lower Hz than the default kernel settings.
+// Its usually 5s, this is 5 minutes
+// Burst 3 means you may get three messages quickly, before the ratelimiting
+// kicks in.
+#define LOCAL_RATELIMIT_INTERVAL (5 * 60 * HZ)
+#define LOCAL_RATELIMIT_BURST 3
+
+#ifdef CONFIG_PRINTK
+#define printk_ratelimited_local(fmt, ...) \
+({                         \
+   static DEFINE_RATELIMIT_STATE(_rs,      \
+                  LOCAL_RATELIMIT_INTERVAL,\
+                  LOCAL_RATELIMIT_BURST);  \
+                           \
+   if (__ratelimit(&_rs))                  \
+      printk(fmt, ##__VA_ARGS__);          \
+})
+#else
+#define printk_ratelimited_local(fmt, ...)       \
+   no_printk(fmt, ##__VA_ARGS__)
+#endif
+
+#define pr_crit_ratelimited_local(fmt, ...)              \
+   printk_ratelimited_local(KERN_CRIT pr_fmt(fmt), ##__VA_ARGS__)
+#define pr_info_ratelimited_local(fmt, ...)              \
+   printk_ratelimited_local(KERN_INFO pr_fmt(fmt), ##__VA_ARGS__)
+
+
 struct rpi_firmware {
 	struct mbox_client cl;
 	struct mbox_chan *chan; /* The property channel. */
@@ -216,9 +246,9 @@ static int rpi_firmware_get_throttled(struct rpi_firmware *fw, u32 *value)
 
 	if (new_uv != old_uv) {
 		if (new_uv)
-			pr_crit("Under-voltage detected! (0x%08x)\n", *value);
+			pr_crit_ratelimited_local("Under-voltage detected! (0x%08x)\n", *value);
 		else
-			pr_info("Voltage normalised (0x%08x)\n", *value);
+			pr_info_ratelimited_local("Voltage normalised (0x%08x)\n", *value);
 	}
 
 	sysfs_notify(&fw->cl.dev->kobj, NULL, "get_throttled");