If you are on a version of norns before 200218 DO NOT run the on device SYSTEM > UPDATE from the norns menu.
You will need to update manually. See here
Fates is an audio and UI platform for Raspberry Pi 3 Model B+ and Pi 4 Model B that provides a stereo audio codec with headphone driver, 3 (or 4) encoders, 3 buttons, a 128x64 OLED display, 2x audio ins, and 2x audio outs.
Fates is fully compatible with the monome norns software ecosystem. A “DIY norns” if you like. Once installed, Fates can be used with the primary norns codebase, without any branches or mods.
Fates can also be used directly with Orac 2.0 (puredata) and also with other Raspberry Pi audio projects like PatchboxOS, etc.
NOTE - this install and norns software has been tested mostly on the Pi3b+ and Pi4b. It may not work perfectly on older/slower Pi models (3b, etc.) and may need different configuration.
- WM8731 stereo audio codec with headphone driver
- NHD-2.7-12864WDW3 128x64 grayscale OLED display
- 3 pushbuttons
- 3 rotary encoders (optional 4th encoder for Orac or other software)
- 2x 1/8in inputs
- 2x 1/8in outputs
- 1/8in stereo headphone out
Fates was designed for Raspberry Pi 3 Model B+ and Raspberry Pi 4 Model B. It’s not been performance tested with earlier Raspberry PI models.
For Raspberry Pi 4, Fates includes a USB-C power jack which fixes the Pi4 issue with "e-marked" USB-C cables not powering the device.
Fates can be powered either from it's own USB-C power jack, or the Raspberry Pi power jack (but NOT both).
BOM - Thru-hole only (for SMD assembled boards)
-
Installing Fates 1.8+ from disk image (recommended)
-
Installing Orac (BETA)
See this troubleshooting doc for more
Fates includes UART pins broken out for a serial connection to another computer using a UART-USB cable.
For example - the Adafruit 954 cable:
- white lead TX
- green lead RX
- black lead GND
- red lead (5v) from the UART cable is not connected on Fates
Then connect using screen
screen /dev/cu.usbserial* 115200
If this does not work, try swapping TX and RX