Update with new options

release/aqualinkd.conf

@@ -131,10 +131,14 @@ report_zero_pool_temp = no
 # Log any packets from this device.
 #serial_debug_filter = 0x00
 
-# Not documented. These will change how RS485 / Serial works, Only use if asked to for problem solving purposes.
+# Not documented. These are experimental.  Will change how RS485 / Serial works, Only use if asked to for problem solving purposes.
 #serial_readahead_b4_write = yes
-#ftdi_low_latency = no
 #prioritize_ack = yes
+
+# Get rid of the startup warning message about no low latency. BETTER option is to buy a better adapter.
+#ftdi_low_latency = no
+
+# Stop the SWG bounce from displaying when using VSP.
 #swg_zero_ignore_count = 20
 
 
@@ -153,6 +157,10 @@ enable_scheduler = yes
 # AqualinkD can only detect a SWG if it's on, so after a restart you will not see/access a SWG until the the next time the pump is on. 
 force_SWG = no
 
+# AqualinkD can take sime time to find heater setpoints (if they exist), This will force the pool & spa
+# heaters to be listed as thermostats vs switches on startup, helps with homekit.
+force_PS_setpoints = no
+
 # Lights can be programmed by control panel or AqualinkD (if controlpanel doesn;t support specific light or light mode you want)
 # IF YOU WANT AQUALINKD TO PROGRAM THE LIGHT, IT MUST NOT BE CONFIGURED AS A COLOR LIGHT IN THE JANDY CONTROL PANEL.
 # Light probramming mode. 0=safe mode, but slow.