TangNano-1K is the new ting FPGA board of GW1NZ-1 FPGA.
Orignal TangNano is based on GW1N-1 FPGA, refer to: https://github.com/sipeed/Tang-Nano-examples
TangNano-1K have independent 27M oscillator for FPGA, and remove the psram chip(but keep the pad), use BL702 for programmer FPGA, refer to https://github.com/sipeed/RV-Debugger-BL702
- RGB led
Blink board led.
Visit example_led/led_pjt
to see this project. Burn the led_pjt.fs
into Tang Nano 1K to check your projuct.
- RGB 5_inch LCD
Drive the 5_inch RGB 40pin lcd screen.
Visit example_lcd/lcd_pjt
to see this project. Burn the lcd_pjt.fs
into Tang Nano 1K to check your projuct.
- RGB 4.3_inch LCD
Drive the 4.3_inch RGB 40pin lcd screen.
Visit example_lcd/lcd_480_272
to see this project. Burn the lcd_43.fs
into Tang Nano 1K to check your projuct.
- RGB 7.0_inch LCD
This screen using the same driver as 5_inch LCD.
When you meet error code PR2017
, just enable corresponding IO as regular IO.
Click Project
in top menu bar and choose Configuration
, then enable the corresponding Dual Purpose Pin to deal with this error.