-
Love the community here and SuperSlicer in general. But in this pause in development I want to nip over to PrusaSlicer to use the new features there. Is there a way to transfer all my settings over? I tried the obvious export/import options but they didn’t seem to work. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 2 replies
-
Simple answer is no. |
Beta Was this translation helpful? Give feedback.
-
Thanks for the replies. Yeah in the end I just opened them both side by side and copied each relevant setting, wasn’t too bad in the end |
Beta Was this translation helpful? Give feedback.
-
to bring Prusa settings to SuperSlicer I open a Prusa .3mf project ..then side by side compare goes much faster. Should work the other way into Prusaslicer. |
Beta Was this translation helpful? Give feedback.
Simple answer is no.