-
-
Notifications
You must be signed in to change notification settings - Fork 519
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Decouple Retraction & Wipe (for Wipe only when crossing perimeters) #4293
Comments
Workaround: Retract only when crossing perimeter =true + Wipe while retracting =true + Retract on layer change =false That brings similar functionality but disables retractions inside the model. |
understood, i'll check if the restriction can be lifted without too much work. |
The issue is that currently, wipe can only be done with a retraction. To decouple the two, a good amount of work & testing is needed. |
Well, wipe should be done with a retraction. But retraction should not be done with wipe ;) |
if it's the last travel, maybe there is a layer change after, and if the retraction is enforced for the layer change, there will be a wipe? |
Yes, true, retraction is enforced before layer change. But wipe is not necessary if it is nor crossing perimeter. Wipe only when crossing perimeter. |
Did I miss something or it's true that checkbox for "Retraction Wipe - Wipe only when crossing perimeters" doesn't work for vast range of SS version, including the latest?
I discovered that just recently when I didn't want retraction wipe unless nozzle goes outside the model's wall.
The text was updated successfully, but these errors were encountered: