ExportToPS Ironing problems (double layer prints?)

[mocksoul]

Version

ExportToPS Edition (2.3.55.2)

Operating system type + version

Windows 10 x64

3D printer brand / version + firmware version (if known)

klipper / voron

Behavior

Sometimes SuperSlicer tries to print layers twice oO.
In the included 3mf top prusa ironing made 2 times (with huge overextrusion).

over_bridge_flow_test.zip

You can see this in this screen:

But if you change top pattern to "ironing" and turn off "ironing post process" (e.g. switch to superslicer ironing) - for some reason second layer is printed twice with same huge overextrusion:

Here two (both strange :)) results:

[mocksoul]

Fixed in nightly? Should I try?

[supermerill]

not yet. The commit has to show here, and then you can grab the nightly that will be built after that.

[mocksoul]

Thanks! I see 👍

[mocksoul]

Tried latest build. Original issue fixed, but still there are problems:

sometimes superslicer tries to put perimeters on top of prusa-style ironing layer. In the image below top ironing was done properly, but where is perimeter on top of ironing in the bottom of the image:

front_rear_skirt_a_300_x2.zip