The yoke is .. fine .. but I do not like the haptic controls at all. I've driven @ 5k miles, and they just aren't good. I decided to fix it for myself, and will share my work.
The Plaid uses a lot of the parts bin from the Model 3/Y, and that's a great thing! The electrical architecture of the Plaid is basically just that of an oversized Model 3, which is a smart move for manufacturing simplification.
- The left stalk (signals/brights/wipers) is fully functional. The other side is a work in progress, but I've validated I can change gear via software, so I just need to wire everything up.
- You cannot just put a Model 3 or Y clockspring/SCCM into a Plaid and make it work. The refresh S ignores the CAN messages from this, and more importantly the car refuses to go into drive with an SCCM running firmware it doesn't like.
- The stalk modules can be removed and fit perfectly into the Plaid SCCM because it is literally the same part number as the 3/Y SCCM. You cannot just plug the ribbon cables in, however, since the Plaid's firmware doesn't try to report on the stalks, so they'll just look pretty without doing anything.
- I wrote custom firmware that uses a Particle Photon + Carloop device to send messages that the plaid expects. This took a bit of reverse engineering and I'll post the info to the github link as time allows. I will not directly help anyone who wants to do this, but I wish you luck. It should be relatively easy once I work out the remaining kinks.
- This change is entirely reversible, and no stock hardware is permanently modified. The shrouds with cutouts for stalks are directly out of a Model 3, and the Plaid shrouds are untouched.
TMC forum link with some history/additional info
Part | No. Needed | Link |
---|---|---|
SCCM connector | 2 | https://www.mouser.com/ProductDetail/571-1924393-1 |
SCCM connector pin housing | 2 | https://www.mouser.com/ProductDetail/571-1924396-1 |
MCON 1.2 Pins for connector (F) | 14 | https://www.mouser.com/ProductDetail/571-1670144-1-CT |
MCON 1.2 Pins for improvised connector (M) | 14 | https://www.mouser.com/ProductDetail/571-1718350-2 |
18 or 19 AWG wire | Recommend at least 10 ft, I used four colors to make it easy to organize things. | find it yourself :) |
Part | No. Needed | Link |
---|---|---|
Console connector (F) | 1 | https://www.mouser.com/ProductDetail/571-1-936119-1 |
MQS Pins for above | 4 | https://www.mouser.com/ProductDetail/571-5-962885-1-CT |
Console connector (M) | 1 | https://www.mouser.com/ProductDetail/571-936121-1 |
MQS Pins for above | 4 | https://www.mouser.com/ProductDetail/571-5-965908-1-CT or https://www.mouser.com/ProductDetail/571-5-962886-1 |