liblithium is a lightweight cryptography library that is portable by design. It requires only standard C99 and does not assume 8-bit addressability, making it suitable for use on some DSP architectures as well as mainstream architectures.
liblithium is built on the Gimli permutation and X25519 signatures. The Gimli permutation and the Gimli-Hash function are designed to be high-performance and to have an extremely small footprint. X25519 signatures are related to the more common ed25519 signatures used by NaCl and others, but use only the x-coordinate of elliptic curve points, a technique pioneered in the paper "Fast and compact elliptic-curve cryptography" and implemented in the STROBE project. This technique greatly reduces the code size required for creating and verifying signatures. liblithium's X25519 implementation is derived from STROBE.
While you can embed liblithium in many environments, the library comes with a SConstruct file for building using scons by default.
You can also use the docker.bash script that will build a
docker image with the necessary build dependencies and run a container.
From within this container, run scons.
liblithium is particularly well-suited for constrained environments and low-power microcontrollers due to its very small footprint and limited processing requirements. This makes liblithium a great candidate for implementing signed firmware updates on embedded electronics that have no secure boot functionality.
Before anything else, you should ensure that all debug ports (e.g., JTAG) on your target MCU are disabled, since those can be used to circumvent software-only signature verification.
Signature verification should ideally be implemented in the bootloader, either at boot time, or only at firmware update time if boot speed is critical. Note that for update-time-only checks, this mechanism will only be effective for MCUs where the entire application is stored in internal flash and protected from read/write via a debugger (see statement on JTAG lock above).
The bootloader must contain the public key that will be used for signature verification. The corresponding secret key must be kept confidential and will be used for signing firmware update binaries.
In order for the signature verification process to be effective, the entire firmware binary should be signed (not only the header or a subset of the firmware).
Since signature verification can be done continuously during data reception by the update process, it makes sense to append the signature at the end of the firmware binary, since the signature is required at that point for final verification.
You can refer to examples/lith-sign.c for an example
of how to sign a binary blob with a secret key.
Three calls only are required to implement this:
lith_sign_init(&state);: initializes the liblithium library state (state is alith_sign_state)lith_sign_update(&state, msg, len);: updates the liblithium state for each data block that is being readlith_sign_final_create(&state, sig, secret_key);: is called once all the data is received, and generates the signature using the secret key.
You can refer to examples/lith-verify.c for an
example of how to verify the signature of a binary blob against a public key.
Three calls only are required to implement this:
lith_sign_init(&state);: initializes the liblithium state (state is alith_sign_state)lith_sign_update(&state, msg, len);: updates the liblithium state for each data block that is being read (for instance when reading a file, or receiving data over a serial bus)lith_sign_final_verify(&state, sig, public_key);: is called once all the data and the signature are received, and verifies the signature against the public key.