mediatek: add Qihoo 360T7 support

target/linux/mediatek/dts/mt7981b-qihoo-360t7.dts

@@ -0,0 +1,235 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+/dts-v1/;
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "mt7981.dtsi"
+
+/ {
+	model = "Qihoo 360T7";
+	compatible = "qihoo,360t7", "mediatek,mt7981";
+
+	aliases {
+		serial0 = &uart0;
+
+		led-boot = &led_status_red;
+		led-failsafe = &led_status_red;
+		led-running = &led_status_green;
+		led-upgrade = &led_status_green;
+	};
+
+	chosen {
+		stdout-path = "serial0:115200n8";
+	};
+
+	memory {
+		reg = <0 0x40000000 0 0x10000000>;
+	};
+
+	gpio-keys {
+		compatible = "gpio-keys";
+
+		reset {
+			label = "reset";
+			linux,code = <KEY_RESTART>;
+			gpios = <&pio 1 GPIO_ACTIVE_LOW>;
+		};
+
+		wps {
+			label = "wps";
+			linux,code = <KEY_WPS_BUTTON>;
+			gpios = <&pio 0 GPIO_ACTIVE_LOW>;
+		};
+	};
+
+	leds {
+		compatible = "gpio-leds";
+
+		led_status_red: red {
+			label = "red:status";
+			gpios = <&pio 3 GPIO_ACTIVE_LOW>;
+		};
+
+		led_status_green: green {
+			label = "green:status";
+			gpios = <&pio 7 GPIO_ACTIVE_LOW>;
+		};
+	};
+};
+
+&eth {
+	status = "okay";
+
+	gmac0: mac@0 {
+		compatible = "mediatek,eth-mac";
+		reg = <0>;
+		phy-mode = "2500base-x";
+
+		fixed-link {
+			speed = <2500>;
+			full-duplex;
+			pause;
+		};
+	};
+};
+
+&mdio_bus {
+	switch: switch@0 {
+		compatible = "mediatek,mt7531";
+		reg = <31>;
+		reset-gpios = <&pio 39 GPIO_ACTIVE_HIGH>;
+		interrupt-controller;
+		#interrupt-cells = <1>;
+		interrupt-parent = <&pio>;
+		interrupts = <38 IRQ_TYPE_LEVEL_HIGH>;
+	};
+};
+
+&spi0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&spi0_flash_pins>;
+	status = "okay";
+
+	spi_nand@0 {
+		compatible = "spi-nand";
+		#address-cells = <1>;
+		#size-cells = <1>;
+		reg = <0>;
+
+		spi-max-frequency = <52000000>;
+		spi-tx-buswidth = <4>;
+		spi-rx-buswidth = <4>;
+
+		mediatek,nmbm;
+		mediatek,bmt-max-ratio = <1>;
+		mediatek,bmt-max-reserved-blocks = <64>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition@0 {
+				label = "bl2";
+				reg = <0x0000000 0x0100000>;
+				read-only;
+			};
+
+			partition@100000 {
+				label = "u-boot-env";
+				reg = <0x0100000 0x0080000>;
+			};
+
+			factory: partition@180000 {
+				label = "Factory";
+				reg = <0x0180000 0x0200000>;
+				read-only;
+			};
+
+			partition@380000 {
+				label = "fip";
+				reg = <0x0380000 0x0200000>;
+				read-only;
+			};
+
+			partition@580000 {
+				label = "ubi";
+				reg = <0x0580000 0x6c00000>;
+			};
+
+			partition@7180000 {
+				label = "config";
+				reg = <0x7180000 0x0100000>;
+				read-only;
+			};
+
+			partition@7280000 {
+				label = "factory";
+				reg = <0x7280000 0x0080000>;
+				read-only;
+			};
+
+			partition@7300000 {
+				label = "log";
+				reg = <0x7300000 0x0700000>;
+				read-only;
+			};
+		};
+	};
+};
+
+&switch {
+	ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port@0 {
+			reg = <0>;
+			label = "lan3";
+		};
+
+		port@1 {
+			reg = <1>;
+			label = "lan2";
+		};
+
+		port@2 {
+			reg = <2>;
+			label = "lan1";
+		};
+
+		port@3 {
+			reg = <3>;
+			label = "wan";
+		};
+
+		port@6 {
+			reg = <6>;
+			label = "cpu";
+			ethernet = <&gmac0>;
+			phy-mode = "2500base-x";
+
+			fixed-link {
+				speed = <2500>;
+				full-duplex;
+				pause;
+			};
+		};
+	};
+};
+
+&pio {
+	spi0_flash_pins: spi0-pins {
+		mux {
+			function = "spi";
+			groups = "spi0", "spi0_wp_hold";
+		};
+
+		conf-pu {
+			pins = "SPI0_CS", "SPI0_HOLD", "SPI0_WP";
+			drive-strength = <8>;
+			mediatek,pull-up-adv = <0>; /* bias-disable */
+		};
+
+		conf-pd {
+			pins = "SPI0_CLK", "SPI0_MOSI", "SPI0_MISO";
+			drive-strength = <8>;
+			mediatek,pull-up-adv = <0>; /* bias-disable */
+		};
+	};
+};
+
+&uart0 {
+	status = "okay";
+};
+
+&watchdog {
+	status = "okay";
+};
+
+&wifi {
+	status = "okay";
+
+	mediatek,mtd-eeprom = <&factory 0x0>;
+};

target/linux/mediatek/filogic/base-files/etc/board.d/02_network

@@ -21,6 +21,9 @@ mediatek_setup_interfaces()
 	mediatek,mt7986b-rfb)
 		ucidef_set_interfaces_lan_wan "lan0 lan1 lan2 lan3" eth1
 		;;
+	qihoo,360t7)
+		ucidef_set_interfaces_lan_wan "lan1 lan2 lan3" wan
+		;;
 	tplink,tl-xdr4288|\
 	tplink,tl-xdr6088)
 		ucidef_set_interfaces_lan_wan "lan1 lan2 lan3 lan4 lan5" eth1
@@ -54,6 +57,11 @@ mediatek_setup_macs()
 	bananapi,bpi-r3)
 		wan_mac=$(macaddr_add $(cat /sys/class/net/eth0/address) 1)
 		;;
+	qihoo,360t7)
+		lan_mac=$(mtd_get_mac_ascii factory lanMac)
+		wan_mac=$(macaddr_add "$lan_mac" 1)
+		label_mac=$wan_mac
+		;;
 	xiaomi,redmi-router-ax6000)
 		wan_mac=$(mtd_get_mac_ascii Bdata ethaddr_wan)
 		label_mac=$wan_mac

target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac

@@ -24,6 +24,11 @@ case "$board" in
 		[ "$PHYNBR" = "0" ] && macaddr_unsetbit $addr 6 > /sys${DEVPATH}/macaddress
 		[ "$PHYNBR" = "1" ] && macaddr_setbit $addr 6 > /sys${DEVPATH}/macaddress
 		;;
+	qihoo,360t7)
+		addr=$(mtd_get_mac_ascii factory lanMac)
+		[ "$PHYNBR" = "0" ] && macaddr_add $addr 2 > /sys${DEVPATH}/macaddress
+		[ "$PHYNBR" = "1" ] && macaddr_add $addr 3 > /sys${DEVPATH}/macaddress
+		;;
 	tplink,tl-xdr4288|\
 	tplink,tl-xdr6086|\
 	tplink,tl-xdr6088)

target/linux/mediatek/image/filogic.mk

@@ -155,6 +155,20 @@ define Device/mediatek_mt7986b-rfb
 endef
 TARGET_DEVICES += mediatek_mt7986b-rfb
 
+define Device/qihoo_360t7
+  DEVICE_VENDOR := Qihoo
+  DEVICE_MODEL := 360T7
+  DEVICE_DTS := mt7981b-qihoo-360t7
+  DEVICE_DTS_DIR := ../dts
+  UBINIZE_OPTS := -E 5
+  BLOCKSIZE := 128k
+  PAGESIZE := 2048
+  KERNEL_IN_UBI := 1
+  DEVICE_PACKAGES := kmod-mt7981-firmware mt7981-wo-firmware
+  IMAGE/sysupgrade.bin := sysupgrade-tar | append-metadata
+endef
+TARGET_DEVICES += qihoo_360t7
+
 define Device/tplink_tl-common
   DEVICE_VENDOR := TP-Link
   DEVICE_DTS_DIR := ../dts