Ultra thin 3D printed cases for Keebio Iris Rev.4 PCB, with magnets snapping feature
3D printed case for Keebio Iris Rev.4 PCB
Assumable these using 14mm M3 bolts and nuts (bolts longer than 14mm will stick out and two pieces won't snap together)
Ultra-thin profile, the middle layer is 6.8mm thick and two-piece can be snapped together and held by magnets for easy carry
Added external buttons for easy firmware flashing
I printed the middle layer using translucent filament to get better lighting
Fusion360 file is included for anyone wants to modify themselves
This has been fixed in version 2 by adding extra 1mm rim
Use magnets to snap two pieces togather, note rubber feet are complementary
3D printed parts
14mm M3 bolts and nuts (Has to be 14mm. Or you have to use spacers if longer than 14.
Shorter won't work)
12mm by 2mm magnets
10mm by 3mm rubber feet (3/8" by 1/8")
super glue
(optional some needle file)
layer height 0.15mm
Use supports
In this version, ErgoDox EZ tilt/ tent kit is supported for the middle layer
layer height is 11mm and button has been modded. Use M3 nuts to put them togather
Also added 1mm rims to top and bottom plates and middle layer, so there's extra space for slicing