[TOPIC-GPIO] drivers: sensor: sx9500: convert to new GPIO API

[pabigot]

Use the new pin and interrupt configuration API.

Signed-off-by: Peter Bigot peter.bigot@nordicsemi.no

[zephyrbot]

All checks passed.

checkpatch (informational only, not a failure)

-:11: WARNING:LONG_LINE: line over 80 characters
#11: FILE: drivers/sensor/sx9500/sx9500_trigger.c:168:
+			   GPIO_INPUT | DT_INST_0_SEMTECH_SX9500_INT_GPIOS_FLAGS);

-:19: WARNING:LONG_LINE: line over 80 characters
#19: FILE: drivers/sensor/sx9500/sx9500_trigger.c:175:
+	gpio_pin_interrupt_configure(gpio, DT_INST_0_SEMTECH_SX9500_INT_GPIOS_PIN,

- total: 0 errors, 2 warnings, 32 lines checked

NOTE: For some of the reported defects, checkpatch may be able to
      mechanically convert to the typical style using --fix or --fix-inplace.

Your patch has style problems, please review.

NOTE: Ignored message types: AVOID_EXTERNS BRACES CONFIG_EXPERIMENTAL CONST_STRUCT DATE_TIME FILE_PATH_CHANGES MINMAX NETWORKING_BLOCK_COMMENT_STYLE PRINTK_WITHOUT_KERN_LEVEL SPLIT_STRING VOLATILE

NOTE: If any of the errors are false positives, please report
      them to the maintainers.

Tip: The bot edits this comment instead of posting a new one, so you can check the comment's history to see earlier messages.