Adding JK0654219NL

[ki5libs]

Adding JK0654219NL
Datasheet

Footprint PR

---

All contributions to the kicad library must follow the KiCad library convention

Thanks for creating a pull request to contribute to the KiCad libraries! To speed up integration of your PR, please check the following items:

• Provide a URL to a datasheet for the symbol(s) you are contributing
• An example screenshot image is very helpful
• Ensure that the associated footprints match the official footprint library
  • A new fitting footprint must be submitted if the library does not yet contain one.
• If there are matching footprint PRs, provide link(s) as appropriate
• Check the output of the Travis automated check scripts - fix any errors as required
• Give a reason behind any intentional library convention rule violation.

[gmsotavio]

Hi @ki5libs,

Thanks for your contribution, by the way, it's a nice symbol. Some notes about it.

• Symbol body must have a line width of 10mil (0.254mm), as per KLC S3.3 (http://kicad-pcb.org/libraries/klc/S3.3/).
• It is not required, but the preferred value for pin name position offset is 20mil, as per KLC S3.6 (http://kicad-pcb.org/libraries/klc/S3.6/). You have used 40mil.
• According to KLC S4.1 (http://kicad-pcb.org/libraries/klc/S4.1/) the maximum number of characters in the pin number determines a pin’s length. When there are two characters in the pin number, then 100mil (2.54mm) long pins should be used. Please, change the length of all the pins to 100mil. You have used 200mil.

Please, provide a screenshot of your symbol after provide the changes.

[ki5libs]

Hi @gmsotavio,

thanks for review. All changes you asked are done. This is changed symbol screenshot

[gmsotavio]

Closing and reopening to force Travis script to run again.

[gmsotavio]

Great. Thank you for your contribution to KiCad libraries and for addressing my suggestions.

Regards,