External LED
Important
If you are looking for BlueSCSI v2 documentation please go here: https://github.com/BlueSCSI/BlueSCSI-v2/wiki
The power PWR and activity ACTpins are on the board behind the SD Card. You can install 1/8w resistors at R1(PWR)/R2(ACT) on the top edge of the PCB. Kits and Assembled units come with 330ohm, but anything between 300-500 should be safe. Your LED will be dimmer the higher the resistance. You can use the calculator at the bottom of this page to calculate the exact resistance you need if you know the LED value.
Connect a LED to 5v with a resistor rated for your LED.
There are a few options which require soldering.
If you are on the latest firmware you can use the same pin, A0 as 1.1 does, you will have to solder it yourself. Remember to add an appropriate resistor between 300-500ohms.
Remove the existing PC13 led and solder on your own, not recommended, but works.
https://www.mouser.com/technical-resources/conversion-calculators/led-series-resistor-calculator
