Prime Edition MkIII. Screen pages
Regardless of the screen page being selected, the Prime Edition Mark III does execute the same background tasks all the time.
It means that, when your primary traffic display is the XCSoar or LK8000 app running on a mobile device connected to the Prime Mark III by Wi-Fi or Bluetooth LE - it is safe to switch the Mark III into 'Status', 'Baro' or 'G load' screen mode and you will not loose anything this case.
ID - unique device ID of this Prime Mark III unit
PROTOCOL - current radio protocol in use
RX - radio packets received
TX - radio packets transmitted
ACFTS - a number of aircrafts 'in sight'
SATS - a number of satellites in use
FIX - indicates if the device has a positive GNSS fix
UPTIME - time since power on or reset
BAT - battery voltage
In this example, a traffic object (the first one out of two) is at 7 o'clock (relative to the current GNSS ground track), 0.8 km out and 262 meters below of the SoftRF carrier aircraft. The air traffic type is Glider:
One may see this picture when there is no any traffic around:
All the display units on this screen are metric unless the 'US/CA' Region setting is selected. In the latter case all the display units are imperial ones.
Note
'Baro' page is not available when the air pressure sensor is missing.
Warning
Reported values may deviate from true values at any time.
Note
'G load' page is not available when the IMU sensor is missing.
Warning
Uncalibrated reading is displayed - it may deviate from true 'G load' value at any time.
