Bosch POF 1200 AE
MaslowCNC Wiki: Electronics | Firmware | Mechanics | Software| Community Garden
Note: This page was copied from the Bosch GOF 2000 CE page, as a starter. Everything on the page needs to be checked, and I don't have this router. I have added a column in the table for people to mark when they have checked the facts.
| Feature | Value | Checked? |
|---|---|---|
| Model # | POF 1200 AE | Yes |
| Cost (approx) | €110, $129aud | Yes |
| Collet size | 6mm | Yes |
| Ease of attaching Z-axis | Possible | No |
| Shaft connector size | 8mm | No |
| Variable speed (y/n) | Yes | No |
| Illuminated (y/n) | No | No |
| Dust collector (y/n) | Yes | Yes |
A Forum post discussing this model can be found at https://forums.maslowcnc.com/t/bosch-pof-1200-ae-height-adjust-modifications/1900
numbers below have been updated Z-Axis depth 55 mm (checked) Weight 3,4 KG (checked) Watts (W) Mechanic horsepower (hp(I)) Electric horsepower (hp(E)) 1200 W) ) 0.8716644 hp) 1.609227 hp
Ned's modification for the z-axis, available just about everywhere.
Spindle fix knob is blocking the path for z-motor mount (solved by turning it), spindle shaft close to router housing, over powered, over priced, power on the right handle. It is high, so a modification of the Z-Axis mount is required.
By jwolter ! Gero reports that the 7" dlang top-mont kit will clear the ~ 30cm wide handles of a Bosch GOF2000 CE, so it might clear this one too, but we need someone to test that.