Skip to content

CN26_UPXtreme

Jump to bottom
AAEONAEU-SW edited this page Apr 12, 2021 · 3 revisions

How to enable and access USB 3.0 IO on CN26

Locating CN26 pin on your UP Xtreme

Please refer to the image below to identify CN26. UP Xtreme CN26 info

Pin Signal BIOS
26 GPIO22/SPI_1_FS1 GPIO23

To open the USB3.0 for Net Plus, you will need to change the following BIOS setting

  • Press Del to enter CRB BIOS settings with password “upassw0rd”
  • Main --> CRB Setup --> CRB Chipset --> PCH-IO Configuration --> PCI Express configuration --> change "Docking Port Auto Detection" from Enabled to Disabled, and set "Docking Port 5 Mulitifunction Selection" to USB.
  • Press [F4] key to save the configuration and reset. Then the system will show a message "Docking Port configurations Changed", please turn off AC power, then turn ON to take effect".

Here are the settings, settings_usb3.0_cn26

Find the right mating connector and crimps for the pins, refer https://www.digikey.com/en/products/detail/jst-sales-america-inc/SHDR-30V-S-B/759926

Contact needed for each pin they for it, refer https://www.digikey.com/en/products/detail/jst-sales-america-inc/SSH-003GA-P0-2/759924

NOTE: This wiki is the main source of documentation for developers working with (or contributing to) the UP products. If this is your first time hearing about UP, we recommend starting with our main UP website, and our UP community page.

UP Wiki

Home

Boards

Community Forums

Downloads

Shop

Clone this wiki locally